Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Short-to-ground on drivers 3 When using 'Pressure Advance'

    Scheduled Pinned Locked Moved
    General Discussion
    maestro
    2
    3
    667
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Kep0aundefined
      Kep0a
      last edited by

      Duet Maestro 2.01 beta 2
      Cartesian Folgertech FT-5 r2 (e3d with bondtech, direct drive if that helps)
      config9_30_18.g

      Adding M572 D0 S0.05 at start g-code in cura. Throws me Error: short-to-ground on drivers 3 30-40 seconds into printing and subsequently every 5-10 seconds. Extrusion is intermittent. I don't notice any heat from the stepper. It's just the usual nema17. 1.8deg.

      Thank you for any advice given.

      genghisnico13undefined 1 Reply Last reply Reply Quote 0
      • genghisnico13undefined
        genghisnico13 @Kep0a
        last edited by

        @kep0a update to the latest 2.02RC2, it will solve that problem.

        Kep0aundefined 1 Reply Last reply Reply Quote 0
        • Kep0aundefined
          Kep0a @genghisnico13
          last edited by

          @genghisnico13 Fantastic. Thank you. I was worried I had a bad board! On to figuring out why my cold temps are so low..

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA