@burtoogle interesting. Yeah I was trying to figure that out. I'm unclear, though, if the min flow amount is being hit, and by using Minimum Wall Flow, wouldn't the entire middle layer just not print? I'm still seeing the interior layer.
That does all seem strange though. Do other slicers have a similar issue? How do those behave in the same scenario?
@burtoogle you legend. Looking nearly flawless so far. Thank you so much. @Phaedrux thank you for the troubleshooting as well. It means a lot!
@phaedrux just 3 walls, filling in the corners, towards the top it bevels in and it adds a lot of small movements. I'll try the m350 command
here's actually the cura save. Not sure if it'll pull up all my settings, but here https://drive.google.com/file/d/1SQJS9rVNZgvcfkh1bGqaz4T-ou4MHLjU/view?usp=sharing
@phaedrux said in Trouble with poor extrusion on cylinders:
Can you post the STL?
Is it fairly low polycount, leading to large segment sizes on the curves?
Are you using mesh grid compensation? I notice your Z jerk is rather low, could it be pauses while trying to adjust the z axis?
@burtoogle said in Trouble with poor extrusion on cylinders:
It would also be useful if you could attach the gcode. Thanks.
Here's STL and the cura gcode for the small cylinder I'm getting problems with. I'll add to the original post. high polycount, no mesh bed compensation. The Z jerk, just doubled to 48 but no change. Seems to be rumbling in the actual extruder, if that's anything. 
Hey guys. Getting some strange artifacts specifically printing curves. Here's my config: 0_1543953331098_extruder-problem-config.g
gcode & stl
Sorry for the big pictures. Extrusion just seems wavy and inconsistent. It's a lot worse without pressure advance. (S0.08) It's been awhile but larger parts seem fine, these are quite small, 16mm diameter.
I did increase extruder jerk to 2000mm/min which helped a lot, which I thought was interesting.
FT-5 with Bondtech BMG and E3D V6, Maestro
Firmware Version: 2.02RC5(RTOS) (2018-11-28b1)
Web Interface Version: 1.22.5
Dry PETG
Slicing with Cura 3.6
60mm/s 250-260 / 60 bed
Retraction 2mm / 50mm/s
Wondering if anyone has any thoughts.
Edit: printing the cylinder separately, I notice a lot of inconsistent slow down, vibration, and jerking
@genghisnico13 Fantastic. Thank you. I was worried I had a bad board! On to figuring out why my cold temps are so low..
Duet Maestro 2.01 beta 2
Cartesian Folgertech FT-5 r2 (e3d with bondtech, direct drive if that helps)
config9_30_18.g
Adding M572 D0 S0.05 at start g-code in cura. Throws me Error: short-to-ground on drivers 3 30-40 seconds into printing and subsequently every 5-10 seconds. Extrusion is intermittent. I don't notice any heat from the stepper. It's just the usual nema17. 1.8deg.
Thank you for any advice given.
@3dmntbighker I would connect my duet to my router, but it's too far. So I'm wired directly to my desktop. 
Hello, just got my board today. Excited to be a part of the community.
My understanding of network is very limited. I have setup my Maestro with a static IP (192.168.2.10) and connected through my computers Ethernet interface. (192.168.2.11) I would like to be able connect to the web interface from any device in my network through my computer. Is this possible?
Thank you.