Hey guys. Getting some strange artifacts specifically printing curves. Here's my config: 0_1543953331098_extruder-problem-config.g
gcode & stl
Sorry for the big pictures. Extrusion just seems wavy and inconsistent. It's a lot worse without pressure advance. (S0.08) It's been awhile but larger parts seem fine, these are quite small, 16mm diameter.
I did increase extruder jerk to 2000mm/min which helped a lot, which I thought was interesting.
FT-5 with Bondtech BMG and E3D V6, Maestro
Firmware Version: 2.02RC5(RTOS) (2018-11-28b1)
Web Interface Version: 1.22.5
Slicing with Cura 3.6
60mm/s 250-260 / 60 bed
Retraction 2mm / 50mm/s
Wondering if anyone has any thoughts.
Edit: printing the cylinder separately, I notice a lot of inconsistent slow down, vibration, and jerking