Extruder 0 reports too little movement
unstableTable last edited by
New install on Ender 3, obvious under extrusion on the bed. Tried keeping extrusion clip very loose on the extruder thinking it was a failure to feed filament.
If it's a firmware tuning issue then I'm not sure where to start?
Phaedrux last edited by
You are evidently using a filament monitor. What type of filament monitor is it? How have you configured it in config.g? Have you calibrated it?
unstableTable last edited by unstableTable
@dc42 I am not using a filament monitor of any kind. But I suspect that I have improperly wired the board.
I can get all 3 axes to home properly.
Nozzle and bed get to proper temp.
Any print stops within 2 min and "Extruder 0 reports too little movement"
AndreS last edited by
Check for any M591 commands in your config.g
Post your config.g
After the print aborted type M591 D0 in the console and show the report.