@fcwilt Do you have to have a seperate board for the pt1000 like the pt100? The reason I got rid of the pt100 is because I would keep having to buy the thermistor and replace it. I think the board was frying it somehow. I had to replace it two or three times. I figured the regular thermistor would be easier.

@dc42 It's working now, thank y'all!

@braeden-0 M104 is working btw.

@braeden-0 And I haven't tried the PID tuning, I was wondering how I tune both hot end and heat bed.

@phaedrux Mellow Fly e3

Hello again, I'm having issues with my heaters on my newly upgraded MP Mini Pro. I installed a stm32 board and I'm using DWC to control it. My hot end, whenever I try to begin heating the nozzle, gives me this error.

M568 P0 S205
The M568 command is no longer needed

And my bed is saying that it is rising to slow (it actually turns on and starts heating). Any ideas? Thanks in advance.

@dc42 It's working now, thank y'all!

@braeden-0 Nevermind the issue was my router.

@fcwilt Do you have to have a seperate board for the pt1000 like the pt100? The reason I got rid of the pt100 is because I would keep having to buy the thermistor and replace it. I think the board was frying it somehow. I had to replace it two or three times. I figured the regular thermistor would be easier.

Hello, I've been using my Duet2 Ethernet for some time now, but it just now started messing up when I go to connect to the browser. It's been doing fine, but after a print, I tried to go to the tab that had the control thing open, and it said that it couldn't establish to the server. All of my other printers are working with the Duet web control but this one isn't. It has a mDNS name "sterope". The difference between this and the others are that this one I have to type in "sterope.local" into my browser to access it. The others I copied and pasted the IP to the browser tab. I tried the M552 s0 then M552 S1 P0.0.0.0 to reset it but it said the actual IP was 0.0.0.0. With the others when I do that it gives me a knew IP address, 192.108.57.8 or something like that for the actual IP address. Sterope gives me 0.0.0.0. Thank you in advance.

Hello, I've been having issues with my pt100 so I decided to change it out to a regular thermistor from e3d. However, it didn't work and I learned I need to change something in the gcode. How do I go about doing this? I have a Duet2 Ethernet. Thank you! (Also, I found something on the previous forum but I didn't understand it. I need someone to explain to me how to do it.)