Need some help. PrusaSlicer is no longer allowing me to load to the PrintHost of the DuetPi setup. Any changes I could do to have this work again?
Did i forget a setting? I can manually load the file but not push it from the slicer.

@dc42 I am currently having similar issue were going though mapping or after a while of printing. If the BLTouch is causing it. If the board comes back alive after... I should just swap the BLTouch?

@phaedrux thanks read that and figured out how to manage around it. Now for the Duet 2 breakout board, can I use the Maestro to drive the circuit I need from it to make the Laser work per the documentation?

Looks like I need to know type of input the Heater pin 6 uses to use an equivalent pin on the Maestro.

So I have a Duet Maestro and an expansion break out board.

I appears that the expansion row on Maestro has a servo pin and the other needed pins to run the circuit. I have tried to connect the laser to expansion board using the four wires.

I can't seem to get the C"!servo" pin to work to run the laser.

Am I missing something?

Running RRF 3.3

Someone have config lines?

Using
M452 C"!servo" R255 F200

M3 code is not working

@supraguy You got any extra printed boards?

@thomas_rudloff Did you ever get the Duet Maestro to work with the laser?

I have a Duet 3 with Duetpi. I am watching a print and the BLTouch occasionally releases and triggers back to standby. Sort of to the same thing as a start check.
Any clue as to why...checked the wires and code is good...the pin firing is random and seem to be tied to move or anything.

@dc42 said in Duet 3 Mini 5+ sensorless homing configuration:

Bear in mind that you need to execute a tuning procedure when using stealthChop mode.

I have, but there is a sequence that is needed after setting Stealthchop to make it calibrate the back emf. let me see if I can find the post from dc42

Power it with just the USB....see if everything is working

You check all the fuses?