@droftarts very gratefull for your help, spark was near heater blocks. What do you mean by checking voltage on expansion header?
Latest posts made by fsi
-
RE: Did I just destroyed my Duet 2 Wifi?
-
RE: Did I just destroyed my Duet 2 Wifi?
@droftarts ok, it's bit dusty but hopefully you will see something
-
RE: Did I just destroyed my Duet 2 Wifi?
@droftarts did as you said, the board seems working over usb - answer on M115 was "FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.01(RTOS) ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2018-07-26b2<LF>ok<LF>"
What should I do next? Update firmware?
Filip -
RE: Did I just destroyed my Duet 2 Wifi?
@droftarts big thanks, most leds lights up. Although can't find board in Device Manager, I'll try changing cable.
-
RE: Did I just destroyed my Duet 2 Wifi?
@Argo did as you suggested, but fuse seems conductive
-
Did I just destroyed my Duet 2 Wifi?
Hello,
it's my first post since I bought my duet two years ago, I'm a bit shaky - sorry for my bad English.
So, it all started when I got a message on DWC saying "heater E1 fault - exceeded 15 degrees drop" or something like that. For some inexplicable reason I unscrewed the old heater and started screwing new one WHILE PRINTER POWER ON. As you may expect I made beautiful spark (no smoke) near these green blocks on board, and since then when power on only blue led (VIN) is shining. Although one always on fan is still working, everything else seem broken.
Is there any need for investigating further?
Thanks,
Filip