@bearer said in SD card contents?:

@cip123 said in SD card contents?:

Following my workbee guides I started uploading my config.g and it asked to reboot, however when it rebooted it didn't come back online I had to manually bring it back. Is this normal?

Hard to say without seeing your config file and knowing if is a wifi or ethernet board, etc. Did it connect to your router and obtain a ip address but not enable the web interface? Did it not connect to your wifi? And so on.

Hi, I'm using a duet 3d wifi 32 bit controller. - https://ooznest.co.uk/product/workbee-cnc-full-kit/

The one supplied with this kit.

Thinking that the www/dwc.json! file could be when I formatted the card however I copied all the www files over when I set it up again.

Hi, got the SD working however ran in to a few problems.

Following my workbee guides I started uploading my config.g and it asked to reboot, however when it rebooted it didn't come back online I had to manually bring it back. Is this normal?

Once I brought it back I continued to upload the next few files, update the firmware and add .bin files. However got this error when trying to upload some files - Could not update file 0:/www/dwc.json!

Any ideas?

It does but I was hoping there would be a way to download it more in bulk rather than single files.

I'm new to this and when I had some trouble sorting out passwords I decided (stupidly) just to format the card and start again, but now obviously it's not opening up webcontrol properly.

I have a guide here - https://learn.ooznest.co.uk/Guide/Connecting+Updating+and+Configuring+Your+WorkBee/19?lang=en

The config looks good but I get confused quite quickly with it all. I'm very new to this side of 3dprint/cnc

Hi there,

Trying to get my SD card setup, can anyone provide me with the SD card contents?

https://github.com/T3P3/Duet/tree/master/Duet2/SD Card Contents

I found them here but having trouble finding a way to download the folders

Cheers