Topics created by cip123

@bearer said in SD card contents?:

@cip123 said in SD card contents?:

Following my workbee guides I started uploading my config.g and it asked to reboot, however when it rebooted it didn't come back online I had to manually bring it back. Is this normal?

Hard to say without seeing your config file and knowing if is a wifi or ethernet board, etc. Did it connect to your router and obtain a ip address but not enable the web interface? Did it not connect to your wifi? And so on.

Hi, I'm using a duet 3d wifi 32 bit controller. - https://ooznest.co.uk/product/workbee-cnc-full-kit/

The one supplied with this kit.

Thinking that the www/dwc.json! file could be when I formatted the card however I copied all the www files over when I set it up again.