Reloading the www files to new version 2.07 worked. I guess corruption is everywhere.
Thank you all!

I set up my corexy printer with dual z motors with dual z endstops. It works well using the Bl touch for this purpose did not. Now after homing how do I use the Bltouch? I am assuming that I will need to use a macro.

Reloading the www files to new version 2.07 worked. I guess corruption is everywhere.
Thank you all!

I am printing so I can not turn off But yes when off and I type in the IP the message address can not be reached comes up.

The display is small there is a bunch of info about ram it is cut off at "Never u"

I just ran M540 the MAC addresses do not match Duet looks odd a5:a5:a5:a5:a5:a5

the M122 gave info about ram but no MAC information. The arp -a command, showed the IP and MAC for the Duet

RepRap firmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.03 ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2019-06-13b2
Thank you
Tom

@bearer said in Duet control no longer shows in the browser:

DWC files

When I start the Duet the screen on the display says: WiFi module is connected to access point
"My network with correct IP address"

@bearer said in Duet control no longer shows in the browser:

Response part of the headers

What is the Response part of the headers ?