@cncmodeller Hi, nice find! can you share the link to the app? can't find it

Chrome is complaining about not being a safe site...

weird... in my browser doesn't work, even with a VPN... changed browser and Voilá

It's me or the wiki page is down?

https://duet3d.dozuki.com/Wiki/PanelDue

@Argo i'm on the same boat my friend...

@tekkydave said in inverting Z-probe pin:

Are you using the PP V2.85 board? If so remember you need to move the connector to the next set of pins in from the edge to pick up the 'D' output. Apologies if you already knew that but I keep forgetting myself

Mine works great in analog mode except in 3.01RC5. I prefer analog as you don't need to fiddle with the crappy pots on the pcb. I had a V2 pcb and the pots fell apart after about 20 adjustments. The only downside is the 1/3 slowdown but @dc42 said this in a previous post:

" it's likely that in a future version of RRF3 I will remove the automatic slowdown and replace it with 2 configurable feedrates in the M558 command: a fast feedrate for initial probing, and a slower feedrate for the second and subsequent probes, for those types of sensor that benefit from slow probing."

I didn't knew about that! thanks, i will try, but now is working fine with RC5 as i can now invert the analog pin

@tekkydave i'm using mine in analog mode and is working as intended... Funny thing, never managed to work in digital mode

@dc42 said in inverting Z-probe pin:

I'll enable inversion of analog pins in 3.01-RC5.

THANK YOU!!!

@dc42 said in inverting Z-probe pin:

You are running the piezo in analog mode (P1 in the M558 command). Is that intentional? It might be that pin level inversion isn't working in analog mode.

Yes, that's intentional, because my piezo is under constat preasure and when i switch to digital mode is triggered constantly. i'been using it without troubles on RRF 3.0 using the "I1" parameter but i have no luck inverting the signal on newer versions.

@bearer can't find any examples of how can i do that...