@fcwilt Will try that thank you sir

I just figured out that the homex macro was lifting the Z-axis that was disconnected, i am sorry :S

Hello,
It was a small gap in the linear rails that made the resonance! changed the rails and no noise!
Thank you

@oliof so you saying that G31 has the wrong X and Y values?
G31 P1000 X23 Y5 Z0.1

@droftarts Sorry for the late reply, with the end of the year/vacations, etc I didn't have the proper time to reply and work on this printer problem. Bellow the pictures asked.
The bed is warped (I used a light source below the ruler to see it better but the bed compensation should compensate for that no?)

@droftarts
As i understood to make the mesh manually the nozzle will travel to the first position then it waits for me to jog the Z and then I should click somewhere or send some command right? i tried to look for this and didn't found.
I have 3D printers since 2011 and i followed the innovations closely. I have a Cartesian (duet) with BLtouch that works fine, i don't touch the bed for years.
Maybe I need to flash the duet again?

@droftarts This mesh.g is a non-ending loop
I am in a death end
I don't know what to do next, get a new bed? the firmware should compensate the difference on a 130mm cube its not even on the entire bed, its on a small 130mm cube
I still believe there is something wrong with software, its not hardware

@fcwilt said in G32 doesnt save after True Bed Leveling:

In any case you have been using G32 to do automatic bed leveling using the two Z steppers.

I don't have mesh.g can you share it please?

@droftarts ![alt

The picture of the axis
Since i don't use mesh.g maybe its a good idea to try it?
I tried to manually do the mesh but with G29 k1 but didn't find in the documentation how can i validate each position

@droftarts Yes, he bed compensation is enabled with the M375 P"heightmap.csv"

Is the superpinda correctly defined?
M558 P5 C"^zprobe.in" H5 F300 T8000 A3 S0.03 ; set z probe to SuperPINDA\

Maybe i need to get a glass and try it out, with glass or mirror the flatness must be perfect.

@droftarts I set the M208 Z-1 but the outcome its the same
The only solution is to source a new bed?
Thank you

@fcwilt Will try that thank you sir

@droftarts That the issue, the print is ok in the middle but not okay in the corners, adjusting the Z trigger won't solve that problem.