Topics created by johny

@johny I would guess that the center of the probe is rather 50mm away from the nozzle than 5mm in the Y direction guessing from the photo you posted. after all, you have a 20mm extrusion between the two, and both the Z probe and the nozzle stick out. So yeah, that's likely off by a lot.

What procedure are you using to flash the Duet?

https://docs.duet3d.com/en/User_manual/RepRapFirmware/Updating_firmware#fallback-procedure-2

This one should get you back up and running. If still not, see this guide.

https://docs.duet3d.com/en/User_manual/Troubleshooting/Duet_wont_respond

i'll try thank you

My thermistor:
100 k thermistor-atc semitec 104gt-2/104nt-4-r025h42g

@johny, I'm glad you solved it!

It heats!!!! Thank you, i rly appreciate it!

Hello,
It was a small gap in the linear rails that made the resonance! changed the rails and no noise!
Thank you