have calibrated my extruder here are my numbers.

1. 311.82
2. 336.82
3. 306.82
4. 339.82
5. 281.82

they all seem inconsistent to me

Example shows an ender 3 i do not own an ender 3

Yes that is the question!

recommended steps per mm for PetG as that is currently the roll of filament i have on the printer

the Sd card from the duet 2 wifi board cause i do not have one for the panel

Failed to load filaments
Directory 0:/filaments not found

i was trying to setup a filaments list for PLA, ABS, PetG

Should i change my "Z" endstop from x2 to x1 cause current tool postition read (x230, y210, z0) i think it should be 200 or 195

when i changed it from x1 to x2 motor direction went in opposite direction so i changed it back to x1

X is at the Right, y is at the Left rear corner

they will work only if i press the plus side of the controls then press the negative side