I used blind joints with my Misumi extrusions and it was worth every penny! Misumi's cuts were spot on and when done, no angle was off my more than .3 degrees using my digital square. And SOLID as a rock to! Thanks to @Nuramori for the suggestion!

@whopping-pochard Outstanding, thank you! I am close to bringing my 're-mixed' BLV MGN online. (remixed as in borrowed ideas from all over the smashed them together in 3Dbuilder since I have no CAD skills

OK, I'm stumped... after four days and 30 reboots of not working and having to full screen out for some inexplicable reason the display is properly going into full screen mode. I didn't change anything... weird.... Not complaining, but cautiously optimistic that I had an anomalous loose wire somewhere that bumped back into place

I am almost finished with my 500x500 triple Z BLV MGN, and went with Duet3 and Toolboard... best decision in my opinion.
The triple Z Axis is easily accommodated and the toolboard greatly reduces the wiring having to run out to the hotend. Still room for plenty of upgrades with the flexibility of the IO ports being able to accommodate just about anything you would want to hook into it.

Well worth the extra cost, in my opinion.

@dc42 oohh that sounds interesting! I look forward to that implementation! So does this mean that I should not be hooking up one of the duet filament monitors to my toolboard yet?

@CaLviNx thank you for sharing that document - much appreciated. i would agree that PID calibration is core function for ensure the best quality prints and would suggest that it is more vital than playing with lights... but then again I am not the one doing the coding - so maybe it is low hanging fruit first

well ok then... I'll do it the hard way and look forward to 3.3 as I do like to run PID calibration every so often

So I read a post that said M303 auto PID is not supported on the toolboard... if that is correct, what is the manual procedure for running PID Calibration? Or am I better off dismounting my hotend and connecting directly to the mainboard?

Any ideas WHY M303 doesn't work on toolboard and when that will be corrected?

@PCR Count me in for one, 2x20 pins would be helpful send me details of how to pay and cost of shipping to 96744 USA

I've had both a 7" PanelDue and a 7" rPi touch screen. The rPI is the better/easier solution to implement, and provides more flexibility if you want to do other things with the screen later.

@PCR why not... I'll give it a go. Looking forward to it! So I should go ahead and order the board and display? Any parameters/features I should be looking for? i assume any ESP devboard should work... but what about the screen?

@PCR I'm in assuming it isn't stupid expensive -- Could I have more details on intended cost and functionality... is this an 'all in one kit'? DIY?

@PCR When the PCB is done... sign me up for one! I love the idea of the RepPanel, but have limited skills and time to implement... so the more plug and play the better

I used blind joints with my Misumi extrusions and it was worth every penny! Misumi's cuts were spot on and when done, no angle was off my more than .3 degrees using my digital square. And SOLID as a rock to! Thanks to @Nuramori for the suggestion!