@Veti So I am noticing that my HotEnd is listed as Heater 1. Should I switch my cables over to 1 instead of 0?

@Veti oof. Talk about crash coursing in 3dPrinting. lol

Now about the sensor, I already have the TH3D control box that replaces the switch itself and just plugs into the Z stop position on the controller. Is it advised to not do that anymore and just connect only by what's mentioned in what you linked?

@Veti I'll read over those. Thank you.

Now I am also getting this when testing the bed. Seems it's warming up pretty slow. 1 degree in about 6-8 seconds.

@Veti added the 1 to both lines that was missing it. Restarted and now to see what it says. Thank you for pointing that out. I had gone through that process a couple times and thought I entered the one like needed. Guess not.

Now my temps are reading the way they should. Now just continue through the setup process from the config setup portion? Also, does it mention where or how to adjust for using a TH3D EZABL Pro for my Z axis?

@Veti Ah thank you. I take it I need to go through the configurator again to fix that?

@Phaedrux Well, just now moved it to that other set I originally had it on and still the same thing.

@bearer Further up you'll see that it was mentioned for me to move the Therm to this connector. I did originally have it connected to E0 TEMP.

Just to verify

Not my best but not my worst. Pins are seated properly too.

Still doing this after fully power cycling the printer.