@jay_s_uk Thank`s for your support!!!!!!!!!!!!!!!

@jay_s_uk Thank`s for your support!!!!!!!!!!!!!!!

@FS-TOOLS Thank`s a lot.

But is there no way, that the error message doesn`t appers or be indicated at the first homing action?

@jay_s_uk Hello jay_s_uk,

this is my homeall.g

How should this command look like?

Best regards

Fabian

Hello everyone, I have the following issue. My large-scale 3D printer is equipped with ball screw spindles and ClearPath SDSK motors on all axes, enabling me to achieve high processing speeds. On the Y-axis, there are two motors controlling individual spindles that run synchronously. In case of an error, I need to trigger an error state. I've managed to do this, but an error is also detected when I first move to the home position. Once the axes are in the home position and the event is cleared, I can move the axes to different positions and induce an error through the mechanics. This induced error is properly recognized at the error input, triggering the event. Now, I could create an error macro that activates during this event. The issue is that this macro also executes when I first move to the home position. I believe the problem lies in the state change of the servo motor output during the initial enable command, resulting in an error. How can I handle this problem?

Best regards

Fabian

@droftarts Hello Ian,

thank`s a lot for your great support. The boards had different RRF.
Both 3HC had RFF. 3.4.4 and the mainboard RRF.3.5.5. But the main problem was that the conditional code was not indented after the statement.

Best regards

Fabian

Hello everyone, I'm experiencing the same issue as CR3D. My setup consists of a Duet3 6XD mainboard and two 3HC boards, using the following firmware (RepRapFirmware for Duet 3 MB6XD 3.4.5). The I0 pins are on the second 3HC board (adress 2) I've made the same settings in the config.g as described here. In the homeall.g, I've implemented the same meta command, but without success. I'm getting undefined errors. Could this be due to the higher firmware version? If so, how should I integrate this?

Link to the topic 3 years ago.

link text

config.g

homeall.g

Best regards.
Fabian

@dc42 Hello everyone, I'm experiencing the same issue as CR3D. My setup consists of a Duet3 6XD mainboard and two 3HC boards, using the following firmware (RepRapFirmware for Duet 3 MB6XD 3.4.5). The I0 pins are on the second 3HC board (adress 2) I've made the same settings in the config.g as described here. In the homeall.g, I've implemented the same meta command, but without success. I'm getting undefined errors. Could this be due to the higher firmware version? If so, how should I integrate this? ```
config.g

homeall.g

Best regards

Fabian
.

@Phaedrux
I mean, that only someone like an admin can change something in the system configurations

Hello,

is it maybe possible to safe the config.g file with a keyword?

Best regards

Fabian