@bubblevisor There are videos for klipper. None for RRF?
Posts made by 7woodman7
-
RE: Input Shapingposted in General Discussion
-
RE: Input Shapingposted in General Discussion
Hi!
Issue is fixed. I replaced the original sd-card with a much faster and the error is gone. Now i just need help on interpreting the graph
-
Input Shapingposted in General Discussion
Hi,
I just wanted to record some data but I got this message every time:
"The selected motion profile contains overflows. It may not be accurate."
My printer is a RatRig Core-3 CoreXY with a Duet Mini5+ board an a LIS3DSH accelerometer.
Thx a lot!
Woody
-
RE: BL Touch hangs sometimes when probingposted in General Discussion
@phaedrux
At the trigger moment BL Touch interrupted a view seconds and then proceeded.
Since the behavior of the whole DWC got slower and also the "Jobs" list did not finish to load the stl files. I did a M999. Since that, no more hanging BL Touch and Interaction on DWC is back to normal! -
BL Touch hangs sometimes when probingposted in General Discussion
Hi!
Running Duet3 Mini5+ with 3.4.0 and Bl Touch 3 on v-core3 400. Running fine for 3 weeks and now probe sometimes suddenly hangs for some seconds when probing. Also had some “Z Probe already triggered at start of probing move” right in the middle of Bed Leveling! Happens every 10th time or so. Any ideas? Thank you so much!