Hi all,

Is it possible to connect an external SD card reader to Duetwifi directly using the CONN_SD pins? While also using the paneldue using the four wire cable?
This is the link to the card reader I have:
https://www.amazon.in/Solnoi-Electronics-SD-Reader-Arduino/dp/B07J1X11GS

I'm using Duet WiFi 1.03 + DueX2 + PanelDue 7i
Reprapfirmware 2.01

Thanks in advance.

@dc42 Thank you for your reply.

@dc42 Thank you.

Hi all,

Is it possible to control devices like UCS1903 which uses one wire communication with duetwifi?

Thanks in advance.

Hi all,

I have a Duetwifi+Duex2 setup. I've connected a LED strip to fan 4 on the duex. When I turn on the machine the led turns on for a moment and then turns off. Is there a way to stop it from blinking on startup? Why is it happening?

FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.02(RTOS) ELECTRONICS: Duet WiFi 1.02 or later + DueX2 FIRMWARE_DATE: 2018-12-24b1

Thanks in advance .

Hi all,

I've connected the SD Card reader using a 26 AWG ribbon cable and I'm happy to say that its working. I did up to 13 hr long prints. The cable is more than 1m long. The only problem I've noticed is when I started the print from DWC I couldn't pause it using paneldue. Paneldue seemed unresponsive. I only noticed it once. Haven't checked it again.

@dc42 thank you

Hi all,

Is it possible to connect an external SD card reader to Duetwifi directly using the CONN_SD pins? While also using the paneldue using the four wire cable?
This is the link to the card reader I have:
https://www.amazon.in/Solnoi-Electronics-SD-Reader-Arduino/dp/B07J1X11GS

I'm using Duet WiFi 1.03 + DueX2 + PanelDue 7i
Reprapfirmware 2.01

Thanks in advance.

Ok I got it, i was just reading it. Sorry for the trouble.

@dc42 Ok,
Was it different in the previous ones?

@dc42 Thank you.
But why does it return only 60? even though in config it is 6?