Posts made by akhilraju

@dc42 Thank you for your reply.

@dc42 Thank you.

Hi all,

Is it possible to control devices like UCS1903 which uses one wire communication with duetwifi?

Thanks in advance.

Hi all,

I have a Duetwifi+Duex2 setup. I've connected a LED strip to fan 4 on the duex. When I turn on the machine the led turns on for a moment and then turns off. Is there a way to stop it from blinking on startup? Why is it happening?

FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.02(RTOS) ELECTRONICS: Duet WiFi 1.02 or later + DueX2 FIRMWARE_DATE: 2018-12-24b1

Thanks in advance .

Hi all,

I've connected the SD Card reader using a 26 AWG ribbon cable and I'm happy to say that its working. I did up to 13 hr long prints. The cable is more than 1m long. The only problem I've noticed is when I started the print from DWC I couldn't pause it using paneldue. Paneldue seemed unresponsive. I only noticed it once. Haven't checked it again.

@dc42 thank you

Hi all,

Is it possible to connect an external SD card reader to Duetwifi directly using the CONN_SD pins? While also using the paneldue using the four wire cable?
This is the link to the card reader I have:
https://www.amazon.in/Solnoi-Electronics-SD-Reader-Arduino/dp/B07J1X11GS

I'm using Duet WiFi 1.03 + DueX2 + PanelDue 7i
Reprapfirmware 2.01

Thanks in advance.

Ok I got it, i was just reading it. Sorry for the trouble.

@dc42 Ok,
Was it different in the previous ones?

@dc42 Thank you.
But why does it return only 60? even though in config it is 6?

Hi all,
Is there a lower limit on the jerk values that can be set using M566 command?
I have this line in config.g
M566 X1000 Y1000 Z12 E6:6

But when I send M566 from DWC or Paneldue it returns like this.
M566
Maximum jerk rates: X: 1000.0, Y: 1000.0, Z: 60.0, E: 60.0:60.0

I cannot set E axis jerk below 60.

Firmware Electronics: Duet WiFi 1.02 or later + DueX2
Firmware Version: 1.21 (2018-03-21)
WiFi Server Version: 1.21
Web Interface Version: 1.21-RC4

Thanks in advance.

@dc42 Ok. . So maybe I should test if 200 mm is working?

@dc42
Is there a maximum resistance for the ground cable which is possible?

@dc42

Hi,

I've connected them as described in the wiki, with wires of length 70mm between Duet and duex board. To do so I've to place the boards on top of each other. Would it be okay if the wires are say 150 - 200 mm long?

Dear all,

I have a DuetWiFi 1.03 + Duex2 0.8 running from a 24v power supply. Power is connected using 2.5 sqmm wires. I want to place Duet and Duex boards side by side, how long can I run the power cables from Duet to Duex?

Thanks in advance.