When the pin is pushed up during a probing move, by a slight push it doesn't retract itself, it falls down, this can be repeated. It only enters error state when its held up for a bit (For instance when it hits the bed and is pushed up continuously).
I recorded a vid of the above, not during a probing move, but static state, the probe seems to exhibit the same behavior during static/probing move.
The probe behavior when pushed/manipulated, is that directed by " deployprobe.g" and "retractprobe.g",
or by something else? The probe is able to articulate itself just fine by M401 and M402.
@Phaedrux
The video was before i updated the firmware to 2.02, sorry that i did not make that clear.
The probe does indeed deploy itself with a G30 command and mode 9.