Best posts made by AlexLin

for slic3r look here
post send to printer

@dc42 does only apply to G32 or also to G29 mesh calibration?

@chanders https://www.thingiverse.com/thing:2469902

Hi
I thought to ask this as a reply on another question but I figured it could be a topic on its own since I see a lot of people that have offset problem etc with auto bed levelling
Just a quick question here: Are auto bed level(G32) and and mesh(G29) independend from each other? I see that M561 clears bed level whilst G29 S2 clears mesh....So can I do a M561 followed by a G32 to bed level using my 2 z motors and after that G29 S2 and G29?
And can these be used independently, i.e. can I clear M561 and only do G32 and keep using G29 S1 to reuse the mesh height map and vise-versa; can I use G29 S2 and measure a new mesh with G29 without clearing the G32 auto bed level for my motors

Another question regarding this : does the bed leveling using independent motors move the motors once and leave them there or is this like mesh compensation something that adjusts z dependend on the hotend position?

In general I think the relation between G32/G30/M561 vs G29 S1/S2 could be explaned better in the wiki. each is explained well in it self but the relation between the 2 is not very clear

Thanks

for cura there was a plug-in
cura print

I added M703 in start.g.so at the beginning of a print all filaments specifics are loaded

Hi
Is tehre a way to stop a marco from running whilst printing .Was 5 hours into a print a pressed by accedent the wrong marco ...and can now start again

Hi
One of the first things on my wishlist would be the actual print time from the last time a certain file was printed in the gcode file list... And a history of all print jobs with accumulated print time and used filament... And ability to reset it.... It is nice for maintenance to know how many hours the print has been running since the last maintenance.....

I also have this error for most of the time when doing it in the console.wil ltry upgrade to 1.22.2 and firmware 2.02beta