Topics created by aparkin

Also I do not know if it is necasssry but i made sure mesh bed compensation was disabled prior to rehoming and prior to each adjustment. Depending on how the compensation works not doing so could leave you scratching your head on why things are so off.

( you wont need to disable it to rehome once everything is level and you are happy with the mesh compensation results)

yes i see now it stops at my set high 1.50 on home but gose to 0 when printing and i can still lower 0 with move keys my bad i see how it works now

is it possible to set up a 9 point bed meshing ?

The resolution of the 7" panel is only 800x480 pixels, much lower than a tablet. Also it has nowhere near as much memory as a tablet, which limits what we can do. So if you want to run the full web interface, then you are better off buying a cheap tablet.

hi all thanks for the help (dc42)
ok problems

memory card stopped working ( replaced card sorted )
extruder getting hot and over extruding and under extruding and completely failing after 3 hours

turned out i had my blue wire ad snapped inside the sheaf …....while cheeking and rerunning all the wire it fell in half in my hand strange

its now 4 hours into a 6 hour print and back to normal
p.s i got an extra motor in the post now

My printer is just out of network range I did by a range extender but it keeps on getting unplugged
Thanks for the reply