reluctantly, I have given up on the duet board for now at least. I spent countless hours trying to dial in the settings and have not been able to get it to work properly. Sent it into a repair shop, they were also not able to get it to work properly. I have gone back to the stock wiring and Ender 3 board to find out why it is not extruding properly.

I had a spare BLTouch so I just tried installing it with new wiring in hopes that was the issue, it wasn't. I must be doing something wrong or missing something but I can't seem to find what it is.

I tried updating to 2.05.1, same issue unfortunately.

@Phaedrux Firmware 2.03 (2019-06-13b2)
Web 1.22.2

@Phaedrux I just checked the tension on the V wheels, it looks good, there's no play on the rail. I have done PID tuning. I have been testing with the bed cold

@Turbo thanks! I'll give those a try

@Turbo ah OK, that is
M906 X800 Y800 Z800 E900 I30 ; set motor currents (mA) and motor idle factor in per cent

@Turbo Sorry if this is a dumb question but how do I confirm this?

@dc42 I decided to take everything back to step one and go through the entire process again in case I missed something. I am still getting the same issue where the probe reads a different value every time

@jens55 Thank you, I will give that a try. What's odd to me is that it start off printing OK