Best posts made by AZERATE

@phaedrux
For some reason I can't post the M122 results without being flagged for spam

@phaedrux
Thanks for the response. The switch is indeed being used as an endstop for Z and is mounted to the frame. If I delete the G30 command that should get rid of the Z Map commands from popping up, right?

Hello all. Long time listener, first time caller.

I used several Duets on multiple machines over the years, but this one is perplexing.
I'm doing a new build which is a hybrid of all FDM machines I've used, so I used the files for my older Duet Wifi to base my setup off of. However, the older machine uses a IR probe, and my new build uses a standard limit switch. Whenever I try to Home Z on either web interface or PanelDue, it instantnly goes to the Z map command screen when I thought I've already gotten rid of such commands in config.g. Also, the Z only moves a maximum of maybe 5mm before refusing commands without error codes.

I can find Height Map still existing in the Settings>General>Plugins on the web interface, but I can't seem to delete it. Meanwhile, homez.g has a G30 quoting Probe.

I'm best at mechanical builds, but this firmware stuff is really sticking it to me. Any Help?
Thank you in advance.

I want to thank you all very much. I ended up deleting everything related to probe and G30 and now while Z motion homes rrrreeeaaallllyyyyy slow, I was able to make some calibration prints to dial in the machine.

This is a great community and I appreciate you time!