Topics created by B3D

Thanks for info. Cluster size is 64K.
Just upgraded today to:
Firmware Version: 2.02RC4(RTOS) (2018-11-18b5)
WiFi Server Version: 1.21
Web Interface Version: 1.22.5
Will post again if it continues to occur.
Thanks 🙂

@dc42 said in Fans, Extruder Heaters Pulse Many Times on Startup and Reset:

@deckingman said in Fans, Extruder Heaters Pulse Many Times on Startup and Reset:

@b3d Yes, I get this too. I don't have anything other than heaters connected to heater outputs but my hot end fan does a "double blip" on start up or reset - like it boots, then instantly boots again. It's not a big deal for me though.

Have you tried 2.02RC4? You should find it is now a single blip.

Yes - and I mentioned the double blip thing is still present in that RC4 thread as well. It's not a big deal though.

@b3d said in Problem with 3 Independent Z-axis motors and Endstops:

Running CoreXY. Tested with firmware 2.02RC4. First Z axis move after recombining is carried out extremely slowly. Regardless of F value or distance it takes about 30 seconds to complete. I can see all three z axis motors turning very slowly.

Is that when using the same homez.g file that you posted earlier? If not, please post your current homez.g file.