Got a little of success here, if I bypass the whole loop with a jumper wire while probing, the board get the connection and is going to the next step
That means the issue is in the wiring between 3.3v out of the board "probe" port after the pullup resistor AND before board probe input
Must be something with heat or vibration as the loop was "good" with ohmeter
Thanks for your help, I'll keep you posted
You are right dont know why it didn't worked before but I think I only tried from panel wich doest seem to work from there.
Did work from web interface right now, just tried 305 in the slicer and looks like its working as well!
Not sure I need to upgrade firmware then! 
Looks like the thermistor is the culprit even while its still working
Noticed I had 3.003v at the board but 3.297 at nozzle to bed, figured out I must have voltage leakout somewhere, unplugged heater didnt change, unplugged thermistor triggered heater fault but voltage dropped to 3.003v as the board output
Ran a bed leveling without thermistor and its working!
Need to find out what type of sensor they use to change it!
Done deal, swapped the thermistor and everything works flawlessly now!