Hi, sorry if this has been asked before, but is it possible to rename the files on the SD card through the web interface?

Maybe it's staring me in the face but i can't see it.

Cheers
Charlie.

I'm using a Flex3Drive on a Hypercube so my settings wouldn't be any good to you i'm afraid, but Jason should be able to supply the correct settings for the DUET

I've got the exact same thing, can't seem to find any settings that'll get rid of it, S3D or Slic3r.

Using a Duet Wifi on a coreXY not a delta.

I too am not using pressure advance.

If you ever get to the bootom of it please let me know, cheers.

Thanks

I'm using the Duet Wifi on my Hypercube, it's much much better than the RAMPS i was using.

Would it be possible to upgrade a Duet Wifi to Duet Ethernet?

I went for the new 1.18beta, it did give a warning,

Warning: Heater 1 appears to be over-powered and a fire risk! If left on at full power, its temperature is predicted to reach 602C.

Saved with M500.

Cheers
Charlie.

You got me worried there, had to double check. It's definitely wired to 12v.

I'll try M143 and report back.

Cheers

Hi guys,

I'm not sure what i'm doing wrong here, i'm trying to PID tune a 12v 30w E3D hotend,

I'm sending command,

M303 H1 S280 P0.1

But getting error,

Error: Temperature reading fault on heater 1: temperature above limit

no matter what P setting i use i get the same error.

Any suggestions? I can't set S any higher because i get,

Bad parameter in M303 command

Cheers
Charlie.

Ah OK maybe i just hadn't noticed it before.

Cheers
Charlie