I already configured everything, turns out its just t1 to switch the tool back and forth

I just installed a second hotend&extruder and updated my firmware (RRF on LPC (skr 1.4)) and everything shows up right and I can eat the second hotend, but I don't see anywhere to select the second extruder to extrude or retract filament. What do I do so I can control my second extruder?

I'm looking for a good kossel mini effector to print for my Flsun kossel mini. Preferably the designs that have the fisheye connectors near the nozzle instead of near the top of the hotend.

Yes, I have.

Yes that's what I meant, allow it to be slower.

Im running RRF on my skr 1.3, which is running a 12v system so the bed heats up really slowly and triggers a fault because of that. Is there any way to set the minimum heating speed so that this dosnt happen?

@droftarts Thanks, mostly my questions would be about general duet things like how to find the printhead coordinates. LPC stuff i can ask them in the LPC discord.

I have RRF running on my skr 1.3 and I was wondering if i could ask questions here on this forum. Obviously not problems because of the fact that this firmware wasnt meant for lpc devices, but general questions and problems?