Posts made by boriss

Hello!

Could some one help me with Thermistor pull-up resistor nominal? Is it 2.2k?

@engikeneer
Thanks a lot. That is all I need to know!

Could you please tell me if Accelerometer should be always connected to the board? Or does It just needs to identify ringing Hz and can be disconnected after M593 is set in the config? Thank you!

Took my friend's Duet 2 WiFi. No connection issue there.

Do not know what Duet 3 needs

@dc42

• 3.4.0 beta 7

• Checked that three times.

• It is hard to set Incorrect configuration with one line like M955 P0 C"io3.out+io3.in". Tried io1 and io4, in configuration and connection to the board.

• tried 10cm long wires even. Maybe adding a capacitor to the line is a good idea?

Good day!

Trying to connect Accelerometer to Duet 3 Mini 5+. All is done according to the manual - https://duet3d.dozuki.com/Wiki/Accelerometers. Different cables and resistors were checked. But I still get - No Accelerometer found.
After all that I decided to check if my LIS3DH is working at all. Took Arduino board and did the following - https://learn.adafruit.com/adafruit-lis3dh-triple-axis-accelerometer-breakout/arduino

Instead of normal reading, the serial monitor showed me random characters

I went further and found that cause of that is serial bound speed. Did a change 9600 -> 115200 and got normal readings.

Could be that the reason why the Duet does not see an accelerometer? Is there any way to set 115200 via G-code M955?

Thank you!