Hi,
now that I've finally found a way to mount my Toolboard 1LC V1.3 to my Stealthburner CW2 extruder , I now will have to wire it up. And that's why I would be happy to get some clarifications (I'm referring to the documentation most of the time):

1. for using the CAN connection, I only need to bridge the solder jumper without the need to bring a physical resistor into the circuit, right?
2. How crucial is it to especially use twisted pair as CAN wires? I would like to use my Heluflon 0.25mm² (AWG 23) cables because they are quite flexible. Can I do this?
3. Can I use a RJ11 adapter to connect the cables to my Mainboard 6HC? Something like this?
4. If I understand correctly, there are limitations in RRF so that I cannot use my inductive probe Omron TL-Q5MC2 with the toolboard. For the start, I will connect it directly to the Mainboard and then I will likely switch to Voron Tap. Can I connect the sensor of it to the toolboard? I suspect it's probe type 8?!?
5. Do you have any suggestions on how to ground the whole toolhead effectively? I see I can connect a wire to the screws holding the toolboard - where on the metal parts (especially the gears) should I connect a ground wire to?
6. At the moment, I don't see any possibility to connect toolhead LEDs to the Toolboard. It's not crucial, but nice to have nonetheless. Do you have any suggestions on how to do this?

I know, that's quite a bunch of newbie questions, but you would help me a lot in answering!
Thank you!
Christian

@droftarts Thank you both!
I ended up remodeling the Printables Parts as I also needed a different cable chain mount and it was easier to remodel than the other one. Now I'm going to figure out the specialities of the toolboard...

@T3P3Tony Thank you. Yeah, that's what i've found so far as well. I wrote to the user who uploaded this, maybe he will respond. Otherwise will try to remodel this.
Another model I found was this one:
https://www.printables.com/model/710408-duet-1lc-toolboard-rev-11-voron-steathburner-mount
It's for V1.1, but it would be a lot easier to remodel to V1.3.
Is there any benefit on where to put the TB aside from looks?
Should I prefer one over the other?

Hello,
I'm building my Voron 2.4 with a Duet 3 Mainboard HC and a Toolboard 1LC V1.3 because I like having just 4 wires connected from the toolhead to the mainboard.
But actually it's quite hard to find a mount for a toolboard to a Stealthburner / Clockwork2 Extruder anywhere on the internet. I remember seeing some pictures on this forum in the past, but i don't find it anymore.
Could anyone provide me with files for mounting the Toolboard 1LC (preferably V1.3, but any version would do as long as it's in a file format like STEP which I could alter. I would also provide the edited files if so possible and wished for)?
Thank you and kind regards
Chris