Posts made by cglass17

@dc42

Thank you! I will give that a shot.

@cglass17 I would still like to be able to see the Gcode streaming as it is happening if that is possible.

@phaedrux

I figured out what the issue was (I think). It at least seems to be working now. I think it was detecting a stall. I turned that feature off for right now until I get it working properly. Then I can swing back and get that working.

Thanks

@phaedrux

I looked for the setting that you referenced but I could not find it on any of the system tabs. I am using Web Interface Version: 1.22.6. Can you point me to where you are seeing that option?

I am in the process of setting up my new printer. Everything seems to work fine from the Web Control as individual items (Heaters, Fans, Motors, Extruder). However, when I go to print it is doing things that I don't understand. I would like to be able to troubleshoot the GCODE. Is there a way to monitor what commands are being sent? I was using Octoprint before and I could see all of the commands being sent. Is there something similar? Is there a way to debug? I tried M111 S1 but didn't get any additional info.

@dc42 - Yep like @wilriker said 12V. I didn't realize that the steppers could run on either 12V or 24V until you stated it. Thanks for pointing that out. So it sounds like you are confident that if I change the voltage that the motors will be quiet. Sounds like I need to look upgrading all of the electronics based on that.

Yeah, I am already looking at other steppers. But before I bought new ones, I wanted to make sure I couldn't get these working.

Based on reading 42SHDC3025-24B on the back of the stepper, I think these are the specs
https://nl.aliexpress.com/item/LMYSTAR-42-Stepper-Motor-17-Nema-42BYGH-1-8-0-9A-3-96V-with-90cm-Motor/32823911368.html

I have this for the microstepping
M350 X16 Y16 Z16 E16 I1 ; Configure microstepping with interpolation

I have tried
M906 X300 Y300 Z300 E300 I30
varying 300-1000.

They all seem to be the same.

On another note, I see everyone suggesting 16X interpolation. I am confused why this is the suggested setting vs 256.

I just upgraded to the Duet3D WIFI board. Has anyone had any luck with getting the original ANET steppers being extremely quiet? Mine don't seem to be quiet and trying to figure out if they can be made quiet or if I actually need new steppers.