Topics created by Chrashem

@droftarts

I want to give you a feedback: I was wrong! I had to lower the y axis. I adjusted it and now my maximum deviation is about 0.2 mm. I feel good with it!

I printed some califlowers and could fine-tune the Skew with a M556.

I think my machine back in business!

Thx for your help!

@Chrashem I find that very odd. I frequently abort prints on a CoreXY machine and I have never encountered this issue. Neither has anyone else reported it. So I suspect that something is wrong more generally with your Z axis. Some suggestions:

Have you tried reverting to the older firmware, to make sure this isn't a hardware or configuration issue that happened to coincide with the firmware update?

Are you sure that you haven't inadvertently set the Z max speed or acceleration too high, or the motor current too low?