Posts made by damo2142

Thank you I was using a BlTouch but new setup uses an inductive probe so I will wire servo to where the BLTouch pin control was wired. I have all the mechanics done and will finish the wiring and programming this week. I hope this finally gives me a dual extrusion option as tried almost everything else.

I just received my dual switching extruder from Makertech I purchased on Kickstarter. It uses a servo to switch from one extruder to the other. I know I can make it work with Marlin but no idea how to take the Markin instructions and make work on my Duet Maestro. I have finally gotten away from Marlin and upgraded all 4 of my printers to Duet Maestros and love them. I do not want to go back to Marlin in one just to use this new setup. I am confident I have everything set up on the extruders and hot ends but not sure about the tool change/servo code. I know the offset numbers for the hot ends and their angles for servo but not sure how to set up my M280 code and tool change. I assume once this is correct just a matter of slicer settings which I use S3d. Any help would be appreciated as only been using Maestro boards for a couple months now and still learning the code.

Wheeled carriage and was not sure how to mount the level. I am now after some work getting .04 deviation and great prints until about half through a print. I get a slight layer shift for a while then return to normal. I am working on that now. This is a Flsun kossel mini that I could never get to work well prior to switching to duet. By the way excellent product of my 4 printers I have switched from MKS board to duet on 2 of them and they have never worked better. Plan on switching other 2 as budget allow.

Just upgraded delta to Duet Maestro and smart effector. When I run auto calibrate the triggered light on effector always goes green but the z probe status does not always move from 0. Some probe points stay 0 others are anywhere between 150 and 1000 reading. The probe always turns green and then goes to next point so it appears it is actually triggering but not showing. Because of this I cannot seem to get a deviation better than .078.