Topics created by damo2142

Thank you I was using a BlTouch but new setup uses an inductive probe so I will wire servo to where the BLTouch pin control was wired. I have all the mechanics done and will finish the wiring and programming this week. I hope this finally gives me a dual extrusion option as tried almost everything else.

Wheeled carriage and was not sure how to mount the level. I am now after some work getting .04 deviation and great prints until about half through a print. I get a slight layer shift for a while then return to normal. I am working on that now. This is a Flsun kossel mini that I could never get to work well prior to switching to duet. By the way excellent product of my 4 printers I have switched from MKS board to duet on 2 of them and they have never worked better. Plan on switching other 2 as budget allow.