@Carlo said in Very new, issue with palette/duet 2:
Pretty sure @Phaedrux uses octoprint with his palette also
I gave up on the Palette and haven't had the time to try fighting with it again. So I'm afraid i'm not much help here.
It wasn't a connectivity issue though that was the problem it was the inability to keep up with print speed and constantly snapping filament. The slow flow rates needed to successfully print meant days long prints and were so far below the advertised speeds. And they refused to admit there was any problem. The last straw for me was a live stream where they were demonstrating it and the filament snapped live on air right beside the CEO and they completely ignored it.
The hub they were selling at launch was pi zero based which really wasn't powerful enough to run octoprint well. I don't know if they changed to at least use a Pi3 or if they are still sticking to the zero.
There are a few threads and docs on the Palette site that might be of more help.