@blacksheep99
Yeah I'll give it ago again trying to set it up on cura later on its just abit of headscraching and headache then I'll figure it out

@blacksheep99
Worked perfect thank you for that your a life saver
My next question as these sealed spools of filament are no longer made I do have a full one but do u rekon I should make a spool holder and trick the machine because I have tons of standard pla and abs plastic on spools and I would rather use them because I can replace them fairly easily or would the st3di think something is wrong I'm not sure how smart this machine actually is tbh I'm not sure if u managed to use other rolls of filament and if so how

@blacksheep99 what would be ideal if I could get hold of the editor but I think the company went bust some time ago been looking online just incase someone made a copy of it but no look finding st3di edit

@blacksheep99
My g codes don't look the same mine say this
FLAVOR:Marlin

;TIME:31184

;Filament used: 8.0111m, 0m

;Layer height: 0.15

;MINX:60.218

;MINY:60.428

;MINZ:0.3

;MAXX:144.789

;MAXY:141.628

;MAXZ:116.55

;Generated with Cura_SteamEngine main

T0

M104 S200

M105

M109 S200

M82 ;absolute extrusion mode

G21 ;metric values

G90 ;absolute positioning

M82 ;set extruder to absolute mode

M107 ;start with the fan off

G28 X0 Y0 ;move X/Y to min endstops

G28 Z0 ;move Z to min endstops

G1 Z15.0 F9000 ;move the platform down 15mm

T1 ;Switch to the 2nd extruder

G92 E0 ;zero the extruded length

@blacksheep99 by any chance to u still have the g code edit?

@hulsie3216 can u send me the settings for cura because I tried slicing something and uploading it to the sd card and nothing shows?