After updating to beta 4.1, everything works fine. Thank you jay_s_uk!
Best posts made by Dep
-
RE: Cannot configure thermistor on Toolboard 1LCposted in Duet Hardware and wiring
-
RE: Mesh calibration not working or what am I doing wrong?posted in Tuning and tweaking
@fcwilt Yes, compensation is on. I checked the M122 command, and also it is visible since the bed moves up / down when printing.
-
RE: Gcode: stop current move with deceleration (no emergency)posted in Firmware wishlist
@dc42 Any news on this issue? I decided not to make a new topic so as not to create duplicates.
-
RE: Bltouch deploy while printing.posted in Duet Hardware and wiring
Yes, it's weird. But I'm just a little tired of figuring out where the problem is.
So I connected the relay:
M950 P1 C"e1heat" ; Power disconnect relay for BLtouch
M42 P1 S1 ; And turn it on right nowAnd after the start of printing, I inserted the command M42 P1 S0
And that's it. Working. I sleep well
Maybe this will help someone. But of course it's better to use Duet 3 toolboard 1LC for the extruder and connect BLtouch there.