Hi guys. Your connection advice is required. I got a 24V compressor with three wires ( brushless motor 24v 8w ). The yellow wire is responsible for speed regulation. How can you organize the connection of a compressor with the ability to adjust the airflow?
I have a duet2 board. Do I need a separate driver or not. Reading the instructions for the motor, I come to the conclusion that the driver is built-in.
The jumpers are currently in this position.
P.S. Now there are 3 connectors involved. Two connectors are always on (blowing the board and hot end) and one on the pwn (blowing the print).