Best posts made by DerGulli

Hello everyone,

i just signed up because i saw this topic on the forums. I encounter exactly the same issue as Omni.

Description:

-Babystepping does not work while printing
-When triggering the offset the value will be shown in the web interface but the Z axis wont move
-I changed the Z height min to -3 but still not work
-when pausing the print baby steps work as intended
-when resuming the print baby stepping won't work again

I am printing with:
-duet wifi
-RepRapFirmware for Duet 2 WiFi/Ethernet 3.1.1 (2020-05-19b2)
-Version von Duet WiFi Server: 1.23
-Prusa slicer 2.2RC5

Thanks

DerGulli

Hello all,

thanks for your support so far ! I checked with M290 and i got the correct readings but by Z axis didnt move.
At the end i tried to reinstall my firmware ending up that baby stepping works now as intended.

I don't know what was messed up.....btw. i used my old config that i posted before.

Best regards and thanks

DerGulli