@dc42 I use ribbon cable and the displayed status is connected, my IP appears but that's it
I used the same panel due to a 2 wifi duet board and it works correctly there

@davea I added a zero in the post but in the config it's correct
M575 P1 S1 B57600

Hello
I have a Duet 3 Mini 5+ with PanelDue, I use RRF3.2.2 and on panel due I have version 3.2.11
I would write command lines for the panel
M575 P1 S1 B576000
When the printer is turned on, the panel lights up, it shows me that the wifi connection has been made, but that's all, I can only access the setup menu
I mention that the duel panel on a printer with duet 2 wifi works
I don't know where the problem comes from
Has anyone else hit her?

there are 3 pairs of arms with different values and they are also in config g

I don't think it helps me because this difference is not constant, I could adjust it from the slicer if it was like that, but it doesn't work
I have for example the following values on one axis, as the others differ
24.68
19.78
14.82
9.95
5.06
print_measure (3).stl

My delta printer does not print in the accurate dimensions, they differ on x and y and are different if the part has different lengths
How can I correct?