Best posts made by Eduma

@T3P3Tony I'm not feeling temperature difference. Once my current print is complete I'll pull the sensor apart and ensure everything is correct.

Am I correct that there is not way to see filament monitor readings without running a print?

@fractalengineer I saw your post yesterday and the design certainly caught my eye. If the filament monitor doesn't pan out for me I was thinking about doing something similar with an E3D or bondtech hob. Do you think your seeing slip on your printed wheel? Or do you think print variation on your encoder disk could cause distance between pulses to inconsistent?

@I_Jedi

I found that the 5V signal to the BL touch was not instance on, but instead "slowly" ramping up to 5V. The BL touch was not seeing 5V fast enough and going in to error. I added a time relay to create a slight delay before powering the bl touch and it remedied my situation.