Best posts made by FBG

Hello everybody,
after send the code for the dsf log this said that trigger6 do the restart...

I checked trigger6 and my config.g and is truth... i did a mistake in the config.g file...

Sorry for that, i was desperate!!

Thanks for your support!

After test a lot time i can say that with "crimped bootlace ferrules" everything is ok.

Thanks a lot!

@gloomyandy I mean turn on/off the output relay

@timschneider thank you!!! now work properly!!

Hello,
I use Duet2 with the latest firmware 3.1.1.
I use a filament runout sensor which is basically a switch.

https://reprapworld.es/products/extruder/extruder_parts/filament_detection/filament_run_out_sensor_1_75mm/

The problem is that when there is filament the switch is pushed and the sensor is on (Led on on the board), if at any time during the printing there is any interference or the diameter is smaller than normal, the sensor is not pushed and the printer pauses and indicates no filament
I think it is usually interference of maybe a few milliseconds, but enough to stop the printer.

My idea is:
When the duet reads the sensor OFF for at least 5 seconds (or 2), the duet reports NO Filament.

I don't know if it is possible to configure this, or maybe with MetaCommands it is possible. I do not think so.

Someone understands me?