Topics created by Flynbrd

Moving the fan around like that may be the reason for the results inconsistent message.

Are you now able to set a temp on the heater? Does it get to temp smoothly without error and does it hold temp in a steady way? If not, maybe try the tuning again but just have the fan on at mid power mid way up so it circulates some air.

@Phaedrux

No, there was no macros folder so I added one.

@dc42 duet 2 wifi
Swiss direct drive + hotend
Crtouch
Non ender touch screen.

Also please post the results of M122 so we can verify that the firmware has actually been applied.

Also post the results of M98 P"config.g" to check your config for syntax errors.

@Borgtribble It depends where you start in the upgrade path. If you're already on 3.x it's a lot more straightforward. The order I've given just ensures you have all the files needed in case you want to go back and forth between versions at some point. I include 3.3 because the firmware folder was added in that release.

@Phaedrux It's strange because regardless of the BL touch and CR touch colors the wires all go to the according spot

For example both Black/blue wires goto the ground on z probe and the White/Red wires goto z probe in. Red/black connects to the +5 on the expansion. Brown/White to ground also on the Expansion. Where can I find the lastest wiring for the CR touch? OR version (probe has atl01 on it)

I found this posted wiring color chart posted in this thread https://forum.duet3d.com/topic/25779/creality-cr-touch-sensor

b8f7799e-56ec-43ee-b113-3a298a3dedb0-image.png