@phaedrux Find !!!!!
there was a construction error in the connector between the cables and the Duet which made that one of the two phases was not powered
so it's good now all my engines are working correctly
but I must now make the BLtouch and my heated bed work
thank you very much for your help and sorry for the inconvenience
@phaedrux Find !!!!!
there was a construction error in the connector between the cables and the Duet which made that one of the two phases was not powered
so it's good now all my engines are working correctly
but I must now make the BLtouch and my heated bed work
thank you very much for your help and sorry for the inconvenience
@phaedrux
I remade a video in clear and precise to help you in my problem.
I also still looked at the polarity of all my motors with a multimeter and everything is good (I have not yet managed to install version 3.3 but I will do it in the evening
video :
https://youtu.be/vC3fRAcn8PQ
@phaedrux already sorry I made a mistake in the second order it is not (G91
G1 H2 X10 F3000)
but (G91
G1 H2 Y10 F3000)
it is the motor called Y which does not work constantly.
and yes I followed what you gave me 3 weeks ago.
I will specify when I execute (G91
G1 H2 X10 F3000) this one is executed normally and in the right direction, i.e. + Y + X
when I execute the command (G91
G1 H2 Y10 F3000) the "bug" command and this one makes a loud noise and seems to want to go in a direction except that it seems to be blocked by something (like in the video I posted)
@foukouda suddenly I would like to ask you if you can make me a customized program I think you are the best for that
(if you don't mind) thank you very much for taking the time to help me
@phaedrux hello. It's been two weeks since I try anything and everything. and I can confirm that the problem comes from the programming and not from the wiring or the mechanical side (motor, driver, ext belt)
for more precision
when I run the G91 command
G1 H2 X10 F3000 this one runs as it should.
but not the command
G91
G1 H2 X10 F3000
and it does the same as in the video that I stink sent
@phaedrux suddenly I did what you ask me and I stink noticed that it is always the engine designed as the X engine that has problems and I can certify that all my engines are well connected and that all my drivers are working correctly
no I have no error message when I execute the command
and it is motor for X that does not work
Hell I have the impression that the printer thinks to be a Cartesian printer yet in the config it is marked
hello I just did what you told me and I could see the problem
when I run a command only 1 motor is running. suddenly I checked that the driver was not broken by exchanging the cables is not that. in addition to that I checked the polarity of my motor and it is well done
I will try to make a video to show you
something else my printer is a BLV mgn Cube this can help
I think I'm going to start from zero take it into account your note.
do you think you can provide me some kind of schema code for coreXY 3d printer on which i can base myself?
Thanks for your help