Topics created by fšk

@o_lampe that is a good observation:). There is an eye icon in the bottom right corner which opens up the usual DWC top panel (this is a feature of the BtnCmd plugin).

Screenshot 2024-11-08 at 14.33.03.png

And if you press the little button with the message bobble icon, it echoes the current polar coordinates to the console.

Screenshot 2024-11-08 at 14.34.45.png

Thank you all for your answers.
I was wondering since im trying to use the filament config.g but it doesn't seem to be called when the printer starts up. I figured out i need to put M703 in the main config.g after selecting the tool. I think this should be mentioned in the docs since just putting it in tpost0.g doesn't seem to do the job on startup .

OK, I figured it out. The config-override.g file was setting up the heaters again after i disabled them in the config file.