Hi guys,
I am George Paul from INDIA. Looking to make some super cool 3d Prints with some custom 3D printers.
Noob at programming and electronics.. but would love to learn more.
Have some crazy ideas and I need some equally crazy support and I dont think there is any place better than the DUET.
Cheers
i am setting up to start developing on the firmware... so have a few queries,
Which is the most stable firmware as of now?? is it version 2.02??
Is there any video or walk through in using Eclipse IDE???
for version 2.02 which branches do i find the source code??
@dc42
ok thank you... will keep this in mind for sure.
Trying to make a walk through with all the hurdles in a small doc to help noobs like me around.
Switch from NO to NC for limit switches in Firmware
Is it possible to develop the firmware using atmel studio instead of eclipse??? If yes is there any steps to build???
I have always worked with the arduino IDE so this is a major leap for me. I have used atmel studio a bit, not a pro though.
i am setting up to start developing on the firmware... so have a few queries,
Which is the most stable firmware as of now?? is it version 2.02??
Is there any video or walk through in using Eclipse IDE???
for version 2.02 which branches do i find the source code??
Well i am sure it will be worth the wait... 8 Expansion boards is like a dream come true. You guys have taken expansion to a whole new level .
I would love to contribute in some way too.
Eager to see the Duet 3 in action too. Is there any way to get my hands on a prototype?
Really cool.
12 stepper drivers sounds good to me.
It is a good start.
Cant wait to start my project. Will come back with more queries as I progress.
Thank You
WoW... 2 more external drivers! where do we connect the 2 external drivers? if the Duet2 is connected to the duex5. Where are the additional pins for more drivers? Do we connect it in the display pins?
@dc42 Do you think the duet2 can be tweaked to fit in a master slave using SPI/ UART with another board??