@gspeterso said in Duet 3 Sensorless Homing Issues:
I had just been sending G1 H1 commands from the console to test. I'm guessing that was my main issue.
It should work with G1 H1 commands from the console, as long as stall detection has been set up and the move is fast enough, and you have reduced the motor current if necessary (as you would normally do in the homing files when using stall detect homing).
BTW I added this section to the wiki page on stall detection recently https://duet3d.dozuki.com/Wiki/Stall_detection_and_sensorless_homing#Section_Minimum_recommended_speed_for_stall_detection.