Best posts made by Handymanpa54

@phaedrux Hi, I think you are correct. I checked back on the order and it is a high temp thermistor. I ordered the one you left a link to, so it should arrive soon. Since the test with a resistor shows near zero I think the software and daughter board are working ok.

@phaedrux said in G28 Z Error: Z probe already triggered at start of probing move:

; Miscellaneous M575 P1 S1 B57600 ; enable support for PanelDue

At this point the z axis homes good,, the paneldue seems to working normal.
Next I want to wire in the hot end.
I saw that photo of you core xy. Very nice!!
Mark

@fcwilt Hey there Frederick. I solved it. X & Y limit switches were swaped even though I thought I paid particular attention to getting them right when wiring! How did that happen! I also found a pin in the connector loose.
Now I need to get the panel du5i working!
Maybe I'll get lucky and have no problems!

Thanks so much!