@HarveyS said in Problems with Setting Tool Offsets in RRF 2.04RC4:
Veti, I was editing my post when you replied. I can, but all this has given my some ideas and let me make some changes, I think I know what to do now to correct this. I'll post the files if I still have issues after I try fixing it up.
If I get this fixed, I'll post them anyway for others who my run into the same thing.
Last edit 11/07/2019 - [Finally read and understood(!) somewhat the documentation, this works....]
Well, I found out what is needed to enable tool offsets in RRF 2.04RC4. Don't need to post the whole config.g all that's needed is just this bit below. You have to define at least 2 tools, ex. the following works:
; ***
; *** Tools
; ***
M563 P0 D0 H1 F-1 ; Define tool 0
G10 L2 P1 X5.00 Y8.00 Z0 ; set tool 0 axis offsets In coordinate space 1
G54 ; set coordinate space 1
G10 P0 R0 S0 ; set initial tool 0 active and standby temperatures to 0C
QuickAlignmentPrint.resized.jpg
